Skip to main content

Using dd on a Mac to copy an ISO file

I downloaded a Fedora ISO file and needed to copy it to a USB memory stick to install on another machine, but the Mac user interface is just enough different from Linux to be annoying:

Hermans-MacBook-Pro:Downloads herman$ sudo dd if=Fedora-18-i686-Live-LXDE.iso of=/dev/disk2
dd: /dev/disk2: Resource busy

Now what?  Some googling later...

Hermans-MacBook-Pro:Downloads herman$ sudo diskutil umountDisk /dev/disk2
Unmount of all volumes on disk2 was successful

Of course, you can also use Disk Utility to unmount the thing.
Hermans-MacBook-Pro:Downloads herman$ sudo dd if=Fedora-18-i686-Live-LXDE.iso of=/dev/disk2

Even Data Definition is different and Ctrl-T will show the dd progress as records in/out.

Raspberry Pi SD Card Images

After copying a RPi image to a SD card, it may be necessary to edit the /etc/rc.local or wpa_supplicant.conf file on the SD card.  To do that, you need to mount the SD card in a Linux virtual machine, since a Mac cannot handle the ext4 file system.  However, when I launched a VM, I found that it cannot connect to the SD card - it isn't visible to the virtual machine.

Solving this is a bit of a headache.  What I eventually did, was to create a special vmdk file that points to the SD card device, then mounted that special virtual disk file in the Linux VM, as described below.

On the Mac, plug the SD card in and run the Disk Utility and unmount the SD card, if it is mounted.  You may need to do this multiple times, so keep it open.

Go to the place where you keep your Virtualbox vmdk files, open a terminal and make a special virtual disk file:
$ sudo VboxManage internalcommands createrawvmdk -filename ./sdcard.vmdk -rawdisk /dev/disk2
$ sudo chmod 777 /dev/disk2
$ sudo chmod 777 ./sdcard.vmdk

If you get a busy error, unmount it again (and again...) as shown up above.

Now open VirtualBox Manager and in the SATA Controller, add an existing hard drive and choose the sdcard.vmdk file.

Launch the Linux virtual machine and mount the rootfs partition /dev/sdb2.  If you are lucky, it will be mounted automatically by the desktop environment.  Now you can edit files on the SD card.

After going through the above, I thought that it may be easier to mount the original ISO image in a Linux VM and fix it, before writing it to the SD card - next time!


Popular posts from this blog

Parasitic Quadrifilar Helical Antenna

This article was reprinted in OSCAR News, March 2018: If you want to receive Satellite Weather Pictures , then you need a decent antenna, otherwise you will receive more noise than picture. For polar orbit satellites, one needs an antenna with a mushroom shaped radiation pattern .  It needs to have strong gain towards the horizon where the satellites are distant, less gain upwards where they are close and as little as possible downwards, which would be wasted and a source of noise.  Most satellites are spin stabilized and therefore the antenna also needs circular polarization, otherwise the received signal will flutter as the antennas rotate through nulls. The helical antenna, first proposed by Kraus in 1948, is the natural solution to circular polarized satellite communications.  It is a simple twisted wire - there seems to be nothing to it.  Various papers have been published on helix antennas, so the operation is pretty well understood. Therefore,

Weather Satellite Turnstile Antennas for the 2 meter Band

NEC2, 2 m band, 146 MHz, Yagi Turnstile Simulation and Build This article describes a Turnstile Antenna for the 2 meter band, 146 MHz amateur satcom, 137 MHz NOAA and Russian Meteor weather satellites.  Weather satellite reception is described here .  A quadrifilar helical antenna is described here .   Engineering, is the art of making what you need,  from what you can get. Radiation Pattern of the Three Element Yagi-Uda Antenna Once one combine and cross two Yagis, the pattern becomes distinctly twisted. The right hand polarization actually becomes visible in the radiation pattern plot, which I found really cool. Radiation Pattern of Six Element Turnstile Antenna Only a true RF Geek can appreciate the twisted invisible inner beauty of a herring bone antenna... Six Element Turnstile Antenna Essentially, it is three crosses on a stick.  The driven elements are broken in the middle at the drive points.  The other elements can go straight throug

To C or not to C, That is the Question

As most would know, the Kernighan and Ritchie C Programming Language is an improved version of B, which is a simplified version of BCPL, which is derived from ALGOL, which is the Ur computer language that started the whole madness, when Adam needed an operating system for his Abacus, to count Eve's apples in the garden of Eden in Iraq.  The result is that C is my favourite, most hated computer language , which I use for everything. At university, I learned FORTRAN with punch cards on a Sperry-Univac, in order to run SPICE, to simulate an operational amplifier.  Computers rapidly lost their glamour after that era! Nobody taught me C.  I bought the book and figured it out myself. Over time, I wrote a couple of assemblers, a linker-locator, various low level debuggers and schedulers and I even fixed a bug in a C compiler - not because I wanted to, but because I had to, to get the job done!   Much of my software work was down in the weeds with DSP and radio modems ( Synchronization,